Fox ATS JL/JT Race Series 2.0 Steering Stabilizer
With conventional steering stabilizers, turning in one direction creates an increase in pressure inside the stabilizer as the shaft occupies more volume in the body and displaces the oil. The repercussion is a push or pull steering force felt by the driver as the stabilizer attempts to return to its neutral state. To overcome this unidirectional force, dual opposing stabilizers are often used, but this requires additional mounting hardware and space.
The Factory Race Series 2.0 Stabilizer ATS utilizes an Adjustable Through Shaft (ATS) architecture that eliminates shaft fluid displacement throughout the stabilizer’s entire travel in both directions. The external piggyback reservoir provides additional fluid capacity and utilizes an Internal Floating Piston (IFP) to separate the fluid from the nitrogen gas charge to eliminate cavitation. For increased control that can be tailored to any driving style and setup, an external adjuster provides 24 clicks of adjustment to fine-tune the feel. The result is highly customizable and consistent damping of unwanted steering feedback in a single, bolt-on stabilizer.
Body | 2.0” impact-extruded and CNC machined 6061-T6 clear anodized aluminum body resists rust over time
|
---|
Body Plating | Hard-anodized for a durable finish
|
---|
Reservoir | External reservoir design separates shock oil from the high-pressure nitrogen
|
---|
Components | Black-anodized, CNC-machined 6061-T6 billet aluminum
|
---|
Shaft | 5/8" hard chrome plated heat-treated alloy steel
|
---|
Piston | Race-developed high-flow piston design
|
---|
Valving | Application-specific valving to maximize performance
|
---|
Seals | Redundant sealing pack system main seal, wiper seal, scraper seal
|
---|
Bushings | Quiet nitrile rubber allows for increased suspension articulation
|
---|
Adjustments | Adjuster - 24 clicks of adjustability
|
---|
Extended | 23.190
|
---|
Compressed | 15.070
|
---|
Travel | 8.120
|
---|
Top Mount | Axle Mount
|
---|
Bottom Mount | Eyelet
|
---|
Fitment notes | Axle Mount
|
---|
|
|
---|
SKU: 983-02-0148
Fitment:
2018-Current Wrangler JL/JLU
2020-Current Gladiator
INSTALL NOTE:
This Fox product ships with a factory axle side mount solution. This alone does not solve mounting to any of our steering kits.
If you would like to retain the stabilizer in the factory location you will also need to purchase a "Factory Location Clamp" under the dropdown menu when ordering. This clamp will attach to the Tie Rod End just like the factory.
If you would like to relocate the stabilizer above the tie rod for additional ground clearance you will need a "2-Inch Standard Stabilizer Clamp for Fox ATS" under our dropdown menus when purchasing our steering kits. The clamp provides the connection point to our tie bar. On the axle side, you will need to also purchase a Synergy stabilizer relocation stud to mount the other end of the ATS to the track back bracket. These clamps and Synergy studs are available for purchase on our clamps product page or in the dropdown menus when adding steering to your cart.
As always please give us a call if you are unsure how to adapt the stabilizer to your setup.