TJ to JK Axle Conversion 1-Ton Aluminum Tie Rod and Drag Link (Factory Location/Under Knuckle)

I installed the tie rod and drag link kit to my TJ build that I swapped JK axles in to which also have 14" ORIs. I was concerned with the drag link that I wouldn't have enough droop angle with the knuckles at the pitman arm and the steer knuckle but there is enough flex and everything works as it should. I will say that I did not do the flip kit but I do wish that I would have just to have the extra angle especially since it was same cost. I will likely end up getting the tie rod end and taper fitting to do that modification anyway. They were a bit backed up on production/delivery at the time I ordered but after a short phone call they were all over it and had it to me within a few days. Lightweight and super easy to install.